SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 233 (FIXED AND MOVEABLE WINDOWS SYSTEM)REPAIR INSTRUCTIONSREAR SIDE DOOR WINDOW REGULATOR MOTOR REPLACEMENT
2009 Chevrolet Tahoe Base, 4.8 C

Rear Side Door Window Regulator Motor Replacement

2009 Chevrolet Tahoe Base, 4.8 CSECTION Rear Side Door Window Regulator Motor Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Side Door Window Regulator Motor & Bolt
GM1692297Courtesy of GENERAL MOTORS CORP.
Callout Component Name
WARNING: Refer to SIR Warning .

Preliminary Procedures

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Position the rear door window approximately half way down in the door.
  3. Remove the rear door window regulator. Refer to Rear Side Door Window Regulator Replacement (Power)  or Rear Side Door Window Regulator Replacement (Manual) .
1 Rear Side Door Window Regulator Motor Bolt (Qty: 1)
CAUTION: Refer to Fastener Caution .

Tip:  Disconnect the electrical connector.

Tighten:  9 N.m (80 lb in)
2 Rear Side Door Window Regulator Motor
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.