SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 233 (FIXED AND MOVEABLE WINDOWS SYSTEM)REPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW REPLACEMENT
2009 Chevrolet Tahoe Base, 4.8 C

Front Side Door Window Replacement

2009 Chevrolet Tahoe Base, 4.8 CSECTION Front Side Door Window Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Front Door Window & Bolts
GM1673172Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Position the door window as needed for service.
  2. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
  3. Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
  4. Remove the front side door inner belt sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement .
  5. Remove the front weatherstrip. Refer to Front Side Door Window Weatherstrip Replacement .
1 Front Door Window Bolt (Qty: 2)
CAUTION: Refer to Fastener Caution .

Procedure: 
Loosen the 2 bolts that attach the window to the window regulator.

Tighten:  10 N.m (89 lb in)
2 Front Door Window
Tip:  The window must be tilted downward into the door to remove it.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.