SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 233 (FIXED AND MOVEABLE WINDOWS SYSTEM)REPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW REGULATOR MOTOR REPLACEMENT
2009 Chevrolet Tahoe Base, 4.8 C

Front Side Door Window Regulator Motor Replacement

2009 Chevrolet Tahoe Base, 4.8 CSECTION Front Side Door Window Regulator Motor Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Front Side Door Window Regulator, Motor & Bolts
GM1690814Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Position the door window as needed for service.
  2. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
  3. Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
1 Front Side Door Window Regulator Bolt (Qty: 6)
CAUTION: Refer to Fastener Caution .

Procedure: 
Disconnect the electrical connector.

Tighten:  4.6 N.m (41 lb in)
2 Front Side Door Window Regulator
3 Front Side Door Window Regulator Motor Bolt (Qty: 3)

Tighten:  9 N.m (80 lb in)
4 Front Side Door Window Regulator Motor
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.