SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 233 (FIXED AND MOVEABLE WINDOWS SYSTEM)REPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW OUTER SEALING STRIP REPLACEMENT
2009 Chevrolet Tahoe Base, 4.8 C

Front Side Door Window Outer Sealing Strip Replacement

2009 Chevrolet Tahoe Base, 4.8 CSECTION Front Side Door Window Outer Sealing Strip Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Front Side Door Outer Belt Sealing Strip
GM1673262Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Lower the front side door window to the fully down position.
  2. Tape off the lower window frame to prevent damage to the door.
  3. Remove the outside rearview power mirror. Refer to Power Mirror Replacement .
1 Front Side Door Outer Belt Sealing Strip
Tip: 
  1. Using a suitable tool, lifting upward on the sealing strip end in order to unhook it from the door flange.
  2. Install the sealing strip to the flange of the door from rear to front and push downward until fully seated.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.