SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 23 (FIXED & MOVEABLE WINDOW SYSTEMS)REPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW REPLACEMENT
2009 Chevrolet Tahoe Base, 4.8 C

Front Side Door Window Replacement

2009 Chevrolet Tahoe Base, 4.8 CSECTION Front Side Door Window Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Front Door Window & Bolts
GM1673172Courtesy of GENERAL MOTORS CORP.
Front Side Door Window Replacement

Callout Component Name
CAUTION: Refer to SIR Caution .

Preliminary Procedures

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Position the front side door window approximately half way down in the door.
  3. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
  4. Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
  5. Remove the front side door inner belt sealing strip. Refer to Sealing Strip Replacement - Front Door Window Belt Inner .
1 Front Door Window Bolts (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  10 N.m (89 lb in)


Tip:  Loosen the 2 bolts that attach the window to the window regulator.
2 Front Door Window
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.