SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 23 (FIXED & MOVEABLE WINDOW SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B3821CIRCUIT/SYSTEM TESTING
2009 Chevrolet Tahoe Base, 4.8 C

Circuit/System Testing

2009 Chevrolet Tahoe Base, 4.8 CSECTION Circuit/System Testing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the left rear window switch connector and connect a test lamp from the lockout signal circuit to ground.
  2. Ignition ON, verify that the test lamp illuminates while the rear window lockout function is inactive.
    • If the test lamp does not illuminate test the left rear window lockout signal circuit for a short to ground. If the circuit tests normal replace the BCM.
  3. If the circuits test normal replace the left rear window switch.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.