Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2009 Chevrolet Tahoe Base, 4.8 CSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the ground strap to the vehicle.
- Install the ground strap terminal to the stud.
- Install the engine ground strap nut at the front plenum panel.
Tighten: Tighten the nut to 9 N.m (80 lb in).
- Position the ground strap to the rear of the left cylinder head.
Tighten: Tighten the bolt to 16 N.m (12 lb ft).
- Install the engine ground strap bolt to the rear of the left cylinder head.
- Install the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
CAUTION:
Refer to Fastener Caution
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.