Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2009 Chevrolet Tahoe Base, 4.8 CSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the battery tray to the vehicle.
- Install the 3 nuts securing the battery tray to the battery tray bracket.
Tighten: Tighten the nuts to 20 N.m (15 lb ft).
- Install the nut securing the battery tray to the front fender inner panel.
Tighten: Tighten the nut to 9 N.m (80 lb in).
- Install the battery tray front support.
- Install the battery tray front support bolts.
Tighten: Tighten the bolts to 20 N.m (15 lb ft).
- Install the battery. Refer to Battery Replacement .
CAUTION:
Refer to Fastener Caution
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.