SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 212 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSHEADLAMP CONTROL MODULE REPLACEMENT (ESCALADE PLATINUM)
2009 Chevrolet Tahoe Base, 4.8 C

Headlamp Control Module Replacement (Escalade PLATINUM)

2009 Chevrolet Tahoe Base, 4.8 CSECTION Headlamp Control Module Replacement (Escalade PLATINUM)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Headlamp Control Module Replacement
GM2039271Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the headlamp assembly. Refer toHeadlamp Replacement (Escalade PLATINUM) .
1 ELC Module Screw (Qty: 4)
CAUTION: Refer to Fastener Caution .

Tighten:  Hand tighten the screws evenly after installation of the ELC module to the headlamp connector.
2 ELC Module
Tip:  Pull the module straight from the headlamp connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.