SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 21 (HVAC SYSTEM - MANUAL)REPAIR INSTRUCTIONSRECIRCULATION ACTUATOR REPLACEMENT
2009 Chevrolet Tahoe Base, 4.8 C

Recirculation Actuator Replacement

2009 Chevrolet Tahoe Base, 4.8 CSECTION Recirculation Actuator Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Recirculation Actuator & Screws
GM1696341Courtesy of GENERAL MOTORS CORP.
Recirculation Actuator Replacement

Callout Component Name

Preliminary Procedure

  1. Open the instrument panel compartment door.
  2. Release the instrument panel compartment door stop.
  3. Allow the instrument panel compartment door to open completely.
  4. Disconnect the electrical connector from the recirculation actuator.
1 Screws, Recirculation Actuator (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  1.6 N.m (14 lb in)
2 Actuator, Recirculation
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.