SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 145 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSSTUB SHAFT HOUSING REPLACEMENT
2009 Chevrolet Tahoe Base, 4.8 C

Stub Shaft Housing Replacement

2009 Chevrolet Tahoe Base, 4.8 CSECTION Stub Shaft Housing Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Stub Shaft Housing, O-Ring & Bolts
GM1751559Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedures: 
Remove the power steering gear. Refer to Steering Gear Replacement (Rack and Pinion)  or Steering Gear Replacement (Non-Rack and Pinion)  or Steering Gear Replacement (Two Mode Hybrid) .
1 Stub Shaft Housing Bolt (Qty: 4)
NOTE: Refer to Fastener Notice .

Tighten:  62 N.m (46 lb ft)
2 Stub Shaft Housing
3 Stub Shaft Housing O-Ring (Qty: 2)
Tip:  Grease the stub shaft housing O-Rings with the special grease supplied in the service kit.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.