SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSHOSE REPLACEMENT - WINDSHIELD WASHER
2009 Chevrolet Tahoe Base, 4.8 C

Hose Replacement - Windshield Washer

2009 Chevrolet Tahoe Base, 4.8 CSECTION Hose Replacement - Windshield Washer
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Windshield Washer Pump Hose Assembly & Components
GM1669975Courtesy of GENERAL MOTORS CORP.
Hose Replacement - Windshield Washer

Callout Component Name

Preliminary Procedure

  1. Open the hood.
  2. Remove the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  3. Disconnect the washer hose from the washer pump spout.
1 Windshield Washer Hose Retainer Clip
2 Windshield Washer Nozzle Hose
Tip:  Disconnect the hose at the left rear fender flange.
3 Windshield Washer Pump Hose Assembly
Tip:  Route the new hose in the same location as the old hose was removed from.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.