SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, CHARGING SYSTEM AND STARTING SYSTEMREPAIR INSTRUCTIONSBATTERY POSITIVE CABLE REPLACEMENTREMOVAL PROCEDURE
2009 Chevrolet Tahoe Base, 4.8 C

Removal Procedure

2009 Chevrolet Tahoe Base, 4.8 CSECTION Removal Procedure
    Fig 1: View Of Under Hood Junction Block Cover
    GM1702793Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the under hood junction block cover.
    3. Fig 2: View Of Junction Block & Retainers
    GM1702795Courtesy of GENERAL MOTORS CORP.
  3. Lift the junction block retainers from the locked position (3) and rotate the retainers to the open position (1).
  4. Reposition the junction block.
    5. Fig 3: View Of Positive Battery Cable Connector & (UBEC)
    GM1702797Courtesy of GENERAL MOTORS CORP.
  5. Remove the positive battery cable connector (1) from the underhood bussed electrical center (UBEC).
    6. Fig 4: View Of Mega Fuse Cover
    GM1702800Courtesy of GENERAL MOTORS CORP.
  6. Remove the mega fuse cover.
    7. Fig 5: View Of Generator Battery Jumper Cable & Components
    GM1699546Courtesy of GENERAL MOTORS CORP.
  7. Remove the generator battery jumper cable to mega fuse nut (3).
  8. Remove the generator battery jumper cable terminal (4) from the mega fuse stud.
    9. Fig 6: View Of Positive Battery Cable Channel, Clips & Studs
    GM1702801Courtesy of GENERAL MOTORS CORP.
  9. Remove the positive battery cable channel from the studs on the plenum front panel.
  10. Remove the positive battery cable clips from the studs on the plenum front panel.
    11. Fig 7: View Of Positive Battery Cable
    GM1702803Courtesy of GENERAL MOTORS CORP.
  11. Remove the positive battery cable terminal from the mega fuse stud.
  12. Remove the positive battery cable from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.