Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, CHARGING SYSTEM AND STARTING SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDIAGNOSTIC CODE INDEX
2009 Chevrolet Tahoe Base, 4.8 C
Diagnostic Code Index
2009 Chevrolet Tahoe Base, 4.8 CSECTION Diagnostic Code Index
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| DTC B1325 | B1325 03: Device Power Circuit Voltage Below Threshold B1325 07: Device Power Circuit Voltage Above Threshold |
| DTC B1424 | B1424 00: Device Voltage Low - Theft Deterrent Module |
| DTC B1516 | B1516 08: Battery Current Sensor Performance Signal Invalid B1516 66: Battery Current Sensor Performance Wrong Mounting Position |
| DTC B1517 | B1517 03: Battery Voltage Below Threshold - BCM B1517 07: Battery Voltage Above Threshold - BCM B1517 5A: Battery Voltage Plausibility Failure - BCM |
| DTC B1527 | B1527 00: High Parasitic Load |
| DTC C0895 | C0895 00: Device Voltage - Electronic Suspension Control Module |
| DTC C0899 | C0899 00: Device Voltage Low - EBCM (w/o JL4) C0899 03: Device Voltage Low - EBCM (JL4) |
| DTC C0900 | C0900 00: Device Voltage High - EBCM |
| DTC P0562 (ECM) | P0562: System Voltage Low - ECM |
| DTC P0562 (FPCM) | P0562: System Voltage Low - FPCM |
| DTC P0563 (ECM) | P0563: System Voltage High - ECM |
| DTC P0563 (FPCM) | P0563: System Voltage High - FPCM |
| DTC P0615 | P0615: Starter Relay Control Circuit |
| DTC P0621 | P0621: Generator L-Terminal Circuit |
| DTC P0622 | P0622: Generator F-Terminal Circuit |
| DTC P1668 | P1668: Generator L-Terminal Control Circuit |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.