SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSFIXED & MOVEABLE WINDOW SYSTEMREPAIR INSTRUCTIONSREAR SIDE DOOR WINDOW REGULATOR REPLACEMENT (MANUAL)
2009 Chevrolet Tahoe Base, 4.8 C

Rear Side Door Window Regulator Replacement (Manual)

2009 Chevrolet Tahoe Base, 4.8 CSECTION Rear Side Door Window Regulator Replacement (Manual)
Fig 1: View Of Rear Side Door Window Regulator & Components
GM1692185Courtesy of GENERAL MOTORS CORP.
Callout Component Name
WARNING: Refer to SIR Warning .

Preliminary Procedures

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Position the rear side door window approximately half way down in the door.
  3. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Standard Wheelbase) or Rear Side Door Trim Panel Replacement (Extended Wheelbase) .
  4. Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
1 Rear Side Door Window Bolt (Qty: 2)
CAUTION: Refer to Fastener Caution .

Tip: 
  1. Tape the window to the door frame to prevent it from moving.
  2. Loosen the 2 bolts that attach the window to the window regulator.

Tighten:  9 N.m (80 lb in)
2 Rear Side Door Window Regulator Bolt (Qty: 4)

Tighten:  9 N.m (80 lb in)
3 Rear Side Door Window Regulator
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.