Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSFIXED & MOVEABLE WINDOW SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC B3205CIRCUIT/SYSTEM TESTING
2009 Chevrolet Tahoe Base, 4.8 C
Circuit/System Testing
2009 Chevrolet Tahoe Base, 4.8 CSECTION Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the appropriate window motor.
- Connect a test lamp between control circuit terminal A and control circuit terminal B.
- Ignition ON, command the window UP and DOWN by using the door switch. The test lamp should turn ON when commanding the UP and DOWN states.
- If the test lamp is always OFF during either of the commands, test either control circuit for a short to ground or open/high resistance. If the circuits test normal, replace the door switch.
- If the test lamp is always ON, test either control circuit for a short to voltage. If the circuits test normal, replace the door switch
- If all circuits test normal, test or replace the window motor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.