Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISBODY & FRAMEIGNITION SWITCH/STEERING LOCKIMMOBILIZER SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC B3031CIRCUIT/SYSTEM VERIFICATION
2009 Chevrolet Tahoe Base, 4.8 C
Circuit/System Verification
2009 Chevrolet Tahoe Base, 4.8 CSECTION Circuit/System Verification
IMPORTANT:
When performing the 10-Minute Vehicle Key Relearn Procedure, all keys not learned at that time will be erased and not be recognized. Perform the Adding Keys procedure on all keys or instruct the customer how to perform the Adding Keys procedure should all keys not be present at the time of repair.
- Verify DTC B3055 is not set.
- If the DTC is set, refer to DTC B3055 .
- Verify the scan tool TDM Learn Coded Key parameter displays Yes.
- If not the specified value, perform the 10 Minute Vehicle Key Relearn procedure. Refer to Replacing Keys (Canada) or Replacing Keys (North America except Canada) .
- Perform the 10 Minute Vehicle Key Relearn procedure. Refer to Replacing Keys (Canada) or Replacing Keys (North America except Canada) . The TDM should exit the learn coded key state and DTC B3031 should clear.
- If the TDM does not exit the learn coded key state after the programming attempt, replace the TDM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.