SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMINTERIOR TRIM AND PANELINGREPAIR INSTRUCTIONSLIFTGATE GARNISH MOLDING REPLACEMENT
2009 Chevrolet Tahoe Base, 4.8 C

Liftgate Garnish Molding Replacement

2009 Chevrolet Tahoe Base, 4.8 CSECTION Liftgate Garnish Molding Replacement
Fig 1: View Of Liftgate Window Upper Garnish Molding Assembly & Retainers
GM1671013Courtesy of GENERAL MOTORS CORP.
Callout Component Name
WARNING: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Preliminary Procedure

  1. Remove the liftgate strut. Refer to Liftgate Strut Replacement (Except Avalanche and Escalade EXT) .
  2. Disconnect the power liftgate actuator rod. Refer to Liftgate Actuator Rod Replacement (Except Avalanche and EXT Escalade) .
1 Liftgate Window Upper Garnish Molding Assembly
Tip:  Pull down and out to disengage retainers.
2 Liftgate Window Upper Garnish Molding Retainer (Qty: 9)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.