SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMINSTRUMENT PANEL TRIM AND CONSOLE TRIMREPAIR INSTRUCTIONSCONSOLE REAR TRIM PLATE REPLACEMENT
2009 Chevrolet Tahoe Base, 4.8 C

Console Rear Trim Plate Replacement

2009 Chevrolet Tahoe Base, 4.8 CSECTION Console Rear Trim Plate Replacement
Fig 1: View Of Front Floor Console End Cap Assembly & Screws
GM1693888Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the front floor console compartment bezel. Refer to Front Floor Console Compartment Bezel Replacement (Except Cadillac)  or Front Floor Console Compartment Bezel Replacement (Cadillac) .
  2. Remove the front floor console rear cupholder. Refer to Front Floor Console Cup Holder Replacement (Cadillac)  or Front Floor Console Cup Holder Replacement (Except Cadillac) .
1 Front Floor Console Rear Trim Plate Screw (Qty: 4)
CAUTION: Refer to Fastener Caution .

Tighten:  2 N.m (18 lb in)
2 Front Floor Console Rear Trim Plate Assembly
Procedure: 
Disconnect the electrical connectors.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.