SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEOBJECT DETECTION SYSTEMREPAIR INSTRUCTIONSREAR OBJECT ALARM MODULE SWITCH REPLACEMENT (ESCALADE)
2009 Chevrolet Tahoe Base, 4.8 C

Rear Object Alarm Module Switch Replacement (Escalade)

2009 Chevrolet Tahoe Base, 4.8 CSECTION Rear Object Alarm Module Switch Replacement (Escalade)
Fig 1: View Of Rear Object Alarm Module Switch Assembly (Escalade)
GM1703994Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the instrument panel accessory trim panel. Refer to Instrument Panel Accessory Trim Plate Replacement (Cadillac) or Instrument Panel Accessory Trim Plate Replacement (Except Cadillac) .
1 Rear Object Alarm Module Switch Assembly
Tip: 
  1. Disconnect the electrical connector.
  2. Use a small flat-bladed tool to release the locking tabs on the switch.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.