Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMSREPAIR INSTRUCTIONSSTOP LAMP SWITCH REPLACEMENT (ADJUSTABLE PEDAL)

2009 Chevrolet Tahoe Base, 4.8 C

Stop Lamp Switch Replacement (Adjustable Pedal)

2009 Chevrolet Tahoe Base, 4.8 CSECTION Stop Lamp Switch Replacement (Adjustable Pedal)

Fig 1: View Of Stop Lamp Switch Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Brake Pedal Pin
2	Stop Lamp Switch Assembly Tip: Disconnect electrical connector.
3	Brake Booster Push Rod
4	Stop Lamp Switch Assembly Retainer

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.