Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTIGNITION SWITCH/STEERING LOCKWIRING SYSTEMS AND POWER MANAGEMENT - SERVICE, TROUBLESHOOTING & DIAGNOSISTYCO/AMP CONNECTORS (SENSOR)TERMINAL REMOVAL PROCEDURE

2009 Chevrolet Tahoe Base, 4.8 C

Terminal Removal Procedure

2009 Chevrolet Tahoe Base, 4.8 CSECTION Terminal Removal Procedure

Disconnect the connector from the component.

Fig 1: Inserting Special Tool Into Lower Right Face Cavity

Courtesy of GENERAL MOTORS CORP.

Insert the J 38125-11A tool into the cavity on the lower right hand face of the connector until the terminal release tang access panel slides over.

Fig 2: Pushing Wire Side Of Terminal Toward Connector

Courtesy of GENERAL MOTORS CORP.

Ensure that the terminal release tang access panel is in the correct location to access the terminals.
Push the wire side of the terminal that is being removed toward the connector and hold it in position.

Fig 3: Inserting Tool Into Terminal Release Tang Access Slot (Sensor)

Courtesy of GENERAL MOTORS CORP.

Insert the J 38125-11A into the terminal release tang access slot located behind the access panel of the connector and press down on the terminal while carefully pulling the terminal out of the connector. Always remember never use force when pulling a terminal out of a connector. If the terminal is difficult to remove, repeat the entire procedure.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.