Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTEXTERIOR LIGHTSLIGHTING SYSTEMSREPAIR INSTRUCTIONSFRONT FOG LAMP REPLACEMENT (PLATINUM)

2009 Chevrolet Tahoe Base, 4.8 C

Front Fog Lamp Replacement (PLATINUM)

2009 Chevrolet Tahoe Base, 4.8 CSECTION Front Fog Lamp Replacement (PLATINUM)

Fig 1: View Of Front Fog Lamp Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the front lower bumper filler. Refer to Front Bumper Filler Replacement (All Utility, Avalanche, Cadillac EXT) or Front Bumper Filler Replacement (Z71) . Disconnect the electrical connectors for the front park turn signal lamp and the front fog lamp sockets. The bulbs can be removed after the lamp housing has been removed from the front bumper fascia.
1	Nut (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten: 10 N.m (89 lb in)
2	Front Fog Lamp Assembly Tip: Remove the lamp assembly from the front side of the lower bumper fascia.
3	Fog Lamp Bulb WARNING: Refer to Halogen Bulb Warning . Tip: Rotate the bulb socket counterclockwise in order to remove.
4	Park, Turn Signal Lamp Bulb Socket Tip: Rotate the bulb socket counterclockwise in order to remove.
5	Park, Turn Signal Lamp Bulb Tip: Pull the bulb straight from the socket.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.