Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEOBJECT DETECTION SYSTEMREPAIR INSTRUCTIONSSIDE OBJECT SENSOR REPLACEMENT
2009 Chevrolet Tahoe Base, 4.8 C
Side Object Sensor Replacement
2009 Chevrolet Tahoe Base, 4.8 CSECTION Side Object Sensor Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Raise the vehicle. Refer to Lifting and Jacking the Vehicle . |
|
| 1 | Side Object Sensor Push Pins (Qty:3) Procedure
|
| 2 | Side Object Sensor Shield |
| 3 | Side Object Sensor Bolt
CAUTION:
Refer to Fastener Caution
.
Tighten: 9 N.m 80 lb in |
| 4 | Side Object Sensor Procedure: Unsnap side sensor out of the side sensor bracket. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.