Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009SILVERADO 2500 2WD V8-6.6L DSL TURBOREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINESERVICE AND REPAIROVERHAULREPAIR INSTRUCTIONS104. INTAKE MANIFOLD CROSSOVER INSTALLATION
2009 Chevrolet Silverado 2500 2WD V8-6.6L DSL Turbo
104. Intake Manifold Crossover Installation
2009 Chevrolet Silverado 2500 2WD V8-6.6L DSL TurboSECTION 104. Intake Manifold Crossover Installation
Intake Manifold Crossover Installation
1. Install the intake manifold crossover gaskets.
2. Install the intake manifold crossover.
Caution: Refer to Fastener Caution (Fastener Caution) .
3. Install the intake manifold crossover nuts and bolts in sequence. Tighten the intake manifold crossover nuts and bolts to 10 Nm (89 lb in) .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.