Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009MALIBU LS, 3.5 NREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS AND FUEL - 3.5L - TROUBLESHOOTING & DIAGNOSISSERVICE BAY TESTTEST PROCEDURE
2009 Chevrolet Malibu LS, 3.5 N
Test Procedure
2009 Chevrolet Malibu LS, 3.5 NSECTION Test Procedure
NOTE:
If the Service Bay Test aborts or fails, a DTC will NOT be set.
- Install a scan tool.
- Select the Service Bay Test with the scan tool.
- Follow the instructions on the scan tool.
- If the test aborts, correct the condition for running the test, then retest.
- If the test fails, repair the vehicle for the condition indicated by the failure message on the scan tool.
- Verify that the EVAP inspection/maintenance system status is set to YES.
WARNING:
Refer to Road Test Warning
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.