SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009HHR LT, 2.4 V, STANDARDREPAIR AND DIAGNOSISSTEERINGSTEERING WHEEL & STEERING COLUMNREPAIR INSTRUCTIONSSTEERING ANGLE SENSOR REPLACEMENT
2009 Chevrolet HHR LT, 2.4 V, Standard

Steering Angle Sensor Replacement

2009 Chevrolet HHR LT, 2.4 V, StandardSECTION Steering Angle Sensor Replacement
Fig 1: View Of Intermediate Steering Shaft & Steering Angle Sensor
GM1985847Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Intermediate Steering Shaft Bolt
CAUTION: Refer to Fastener Caution .

Tip:  Secure the steering wheel to keep it from moving once the intermediate steering shaft is disconnected from the steering column.

Tighten:  34 N.m (25 lb ft)
2 Intermediate Steering Shaft
Procedure: 
Mark the alignment of the intermediate steering shaft to the steering column before disconnecting it.
3 Steering Angle Sensor

Procedure

  1. Disconnect any electrical connectors as needed.
  2. Use the alignment bracket on the steering column when reinstalling the steering angle sensor.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.