Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009HHR LT, 2.4 V, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSWIRING SYSTEMS AND POWER MANAGEMENT - ELECTRICAL CENTER ID VIEWS & COMPONENT & SPLICE PACK CONNECTOR END VIEWSCOMPONENT CONNECTOR END VIEWSTAIL/STOP AND TURN SIGNAL LAMP - LEFT
2009 Chevrolet HHR LT, 2.4 V, Standard
Tail/Stop and Turn Signal Lamp - Left
2009 Chevrolet HHR LT, 2.4 V, StandardSECTION Tail/Stop and Turn Signal Lamp - Left
Tail/Stop and Turn Signal Lamp - Left
| Pin | Wire | Circuit | Function |
|---|---|---|---|
| A | 0.35 YE | 18 | Left Rear Stop/Turn Lamp Supply Voltage |
| B | 0.35 BN | 9 | Park Lamp Supply Voltage |
| C | 0.35 BK | 750 | Ground |
Connector Part Information
|
Terminal Part Information
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.