Quarter Upper Trim Panel Replacement (Except AXS)

2009 Chevrolet HHR LT, 2.4 V, StandardSECTION Quarter Upper Trim Panel Replacement (Except AXS)
Fig 1: Identifying Rear Quarter Upper Trim Panel (Except AXS)
GM1606598Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedures:Β 
Disable the roof rail SIR system. Refer to SIR Disabling and Enabling .
1 Quarter Upper Trim Panel Cover
2 Quarter Upper Trim Panel Screw
CAUTION: Refer to Fastener Caution .

Tighten:Β  9 N.m (80 lb in)

3 Quarter Upper Trim Panel Assembly

Procedure

  1. Remove the cargo tie down loop anchor plate and bolt.
  2. Pull the trim panel toward the inside of the vehicle to disengage the retainers.

Tighten:Β  9 N.m (80 lb in)

4 Quarter Upper Trim Clip (Qty: 6)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.