SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009HHR LT, 2.4 V, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEMSREPAIR INSTRUCTIONSFRONT SIDE MARKER LAMP BULB REPLACEMENT
2009 Chevrolet HHR LT, 2.4 V, Standard

Front Side Marker Lamp Bulb Replacement

2009 Chevrolet HHR LT, 2.4 V, StandardSECTION Front Side Marker Lamp Bulb Replacement
Fig 1: Identifying Front Side Marker Lamp
GM1619188Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .

Preliminary Procedures

  1. Remove the forward portion of either the LF or RF wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  2. Reach inside the front bumper fascia and pinch the upper lamp tabs and push the lamp outward from the front bumper fascia then lift upward to remove.
  3. Disconnect the electrical connector.
1 Lamp Assembly, Front Side Marker
2 Socket, Front Side Marker Lamp
Tip:  Turn the socket a quarter turn counterclockwise in order to remove.
3 Bulb, Front Side Marker Lamp
Tip:  Pull the bulb straight outward from the lamp socket.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.