SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009CHEVY EXPRESS G2500, VAN CARGO, 4.8 CREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - ELECTRICAL CENTER IDENTIFICATION, COMPONENT CONNECTOR & SPLICE PACK CONNECTOR END VIEWSCOMPONENT CONNECTOR END VIEWSSEAT ADJUSTER MOTOR ASSEMBLY - PASSENGER (AG2)
2009 Chevrolet Chevy Express G2500, Van Cargo, 4.8 C

Seat Adjuster Motor Assembly - Passenger (AG2)

2009 Chevrolet Chevy Express G2500, Van Cargo, 4.8 CSECTION Seat Adjuster Motor Assembly - Passenger (AG2)
Fig 1: Seat Adjuster Motor Assembly - Passenger (AG2) - Connector End View
GM288397Courtesy of GENERAL MOTORS CORP.
Seat Adjuster Motor Assembly - Passenger (AG2)

Pin Wire Circuit Function
A 3 YE 288 Passenger Seat Rear Vertical Motor Up Control
B 3 L-BU 289 Passenger Seat Rear Vertical Motor Down Control
C 3 TN 296 Passenger Seat Horizontal Motor Forward Control
D 3 L-GN 290 Passenger Seat Horizontal Motor Rearward Control
E 3 D-GN 297 Passenger Seat Front Vertical Motor Up Control
F 3 D-BU 298 Passenger Seat Front Vertical Motor Down Control
Connector Part Information 
  • OEM: 12015344
  • Service: 12015344
  • Description: 6-Way F Metri-Pack 280 Series (BK)
Terminal Part Information 
  • Terminal/Tray: See Terminal Repair Kit
  • Core/Insulation Crimp: See Terminal Repair Kit
  • Release Tool/Test Probe: See Terminal Repair Kit
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.