Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2009CHEVY EXPRESS G2500, VAN CARGO, 4.8 CREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSWIRING SYSTEMS AND POWER MANAGEMENT - ELECTRICAL CENTER IDENTIFICATION, COMPONENT CONNECTOR & SPLICE PACK CONNECTOR END VIEWSCOMPONENT CONNECTOR END VIEWSINFLATABLE RESTRAINT SIDE IMPACT SENSOR (SIS) - RIGHT REAR (PASSENGER WITH ASF WITH E24)

2009 Chevrolet Chevy Express G2500, Van Cargo, 4.8 C

Inflatable Restraint Side Impact Sensor (SIS) - Right Rear (Passenger with ASF with E24)

2009 Chevrolet Chevy Express G2500, Van Cargo, 4.8 CSECTION Inflatable Restraint Side Impact Sensor (SIS) - Right Rear (Passenger with ASF with E24)

Fig 1: Inflatable Restraint Side Impact Sensor (SIS) - Right Rear (Passenger with ASF with E24) - Connector End View

Courtesy of GENERAL MOTORS CORP.

Pin	Wire	Circuit	Function
1	0.5 L-BU/WH	6626	Right Rear Side Impact Sensing Module Signal
2	0.5 PK/BK	6627	Low Reference

Connector Part Information

OEM: 15356717
Service: 88953273
Description: 2-Way F GT 150 Series Sealed (YE)

Terminal Part Information

Terminal/Tray: Service with Pigtail
Core/Insulation Crimp: N/A
Release Tool/Test Probe: 15315247/J-35616-2A (GY)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.