Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2009CHEVY EXPRESS G2500, VAN CARGO, 4.8 CREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEATED GLASS/DEFOGGERSFIXED & MOVEABLE WINDOW SYSTEMREPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW CHANNEL REPLACEMENTREMOVAL PROCEDURE

2009 Chevrolet Chevy Express G2500, Van Cargo, 4.8 C

Removal Procedure

2009 Chevrolet Chevy Express G2500, Van Cargo, 4.8 CSECTION Removal Procedure

Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
Remove the front door rear garnish. Refer to Front Side Door Rear Garnish Molding Replacement .
Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
Lower the front door window.
Remove the inner window sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement .
Remove the outer window sealing strip. Refer to Outer Belt Sealing Strip Replacement .

Fig 1: Front Run Channel & Bolt

Courtesy of GENERAL MOTORS CORP.

Remove the bolt (2) that retains the front run channel (1) to the door.
Remove the front run channel (1) from the door.
Raise the front window approximately half way in order to access the nuts that retain the front door window to the sash. Access the nuts through the holes in the front door module.
Remove the nuts that retain the front door window to the sash.

Fig 2: Rear Run Channel & Bolt

Courtesy of GENERAL MOTORS CORP.

Remove the front door window from the door from the outside of the vehicle.
Remove the bolt (2) that retains the rear run channel (1) to the door.
Remove the rear run channel (1) from the door.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.