Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009CHEVY EXPRESS G2500, VAN CARGO, 4.8 CREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEATED GLASS/DEFOGGERSFIXED & MOVEABLE WINDOW SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESREAR WINDOW DEFOGGER MALFUNCTIONCOMPONENT TESTINGRELAY TEST
2009 Chevrolet Chevy Express G2500, Van Cargo, 4.8 C
Relay Test
2009 Chevrolet Chevy Express G2500, Van Cargo, 4.8 CSECTION Relay Test
- Ignition OFF, disconnect the REAR DEFOG relay.
- Test for 60-180 ohms between terminals 85 and 86.
- If not within the specified range, replace the relay.
- Test for infinite resistance between the following terminals:
- 30 and 86
- 30 and 87
- 30 and 85
- 85 and 87
- If not the specified value, replace the relay.
- Install a 30-amp fused jumper wire between relay terminal 85 and 12 volts. Install a jumper wire between relay terminal 86 and ground. Test for less than 2 ohms between terminals 30 and 87.
- If greater than the specified range, replace the relay.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.