Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009CHEVY EXPRESS G2500, VAN CARGO, 4.8 CLABOR TIMESOTHER VARIANTDRIVELINES AND AXLESDRIVESHAFTS AND UNIVERSAL JOINTSPROPELLER SHAFTREMOVE & INSTALL OR REMOVE & REPLACE
2009 Chevrolet Chevy Express G2500, Van Cargo, 4.8 C
Remove & Install or Remove & Replace
2009 Chevrolet Chevy Express G2500, Van Cargo, 4.8 CSECTION Remove & Install or Remove & Replace
WARNING: This page is about the Chevy Express G1500, Van Cargo, 4.3 X, which is a different variant/trim than selected.
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| G1500,G2500,G3500,H1500, To Rear Axle,One Piece Driveline | 0.5 | C | ||
| G1500,G2500,G3500,H1500, To Rear Axle,Two Piece Driveline,Both | 0.7 | C | ||
| G1500,G2500,G3500,H1500, To Rear Axle,Two Piece Driveline,Front Shaft | 0.9 | C | ||
| G1500,G2500,G3500,H1500, To Rear Axle,Two Piece Driveline,Rear Shaft | 0.5 | C | ||
| Combination Procedure: CENTER SUPPORT BEARING: Remove & Replace: | ||||
| G1500,G2500,G3500,H1500 | 0.3 | B | ||
| Combination Procedure: DIFFERENTIAL PINION FLANGE: Remove & Replace: | ||||
| G1500,G2500,G3500,H1500 | 0.4 | B | ||
| Combination Procedure: DIFFERENTIAL PINION SEAL: Remove & Replace: | ||||
| G1500,G2500,G3500,H1500 | 0.6 | B | ||
| Combination Procedure: PROPELLER SHAFT YOKE: Remove & Replace: | ||||
| G1500,G2500,G3500,H1500, Each | 0.2 | B | ||
| Combination Procedure: SLIP YOKE BOOT: Remove & Replace: | ||||
| G1500,G2500,G3500,H1500, Each | 0.1 | B | ||
| Combination Procedure: UNIVERSAL JOINT: Remove & Replace: | ||||
| G1500,G2500,G3500,H1500, Each | 0.5 | B | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.