Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009AVALANCHE 6.0 Y, RWDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSION - 6L80/6L90 - DTC P0218 TO DTC P0963DTC P06AC, P06AD, OR P06AECIRCUIT/SYSTEM TESTING
2009 Chevrolet Avalanche 6.0 Y, RWD
Circuit/System Testing
2009 Chevrolet Avalanche 6.0 Y, RWDSECTION Circuit/System Testing
- Clear the DTC and operate the vehicle under the condition for running and setting the DTC.
- Shut the ignition OFF for 30 seconds, and verify that the DTC does not reset.
- If the DTC resets, replace the control solenoid (w/body and TCM) valve assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.