SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008UPLANDER V6-3.9LREPAIR AND DIAGNOSISSTARTING AND CHARGINGDIAGRAMSDIAGNOSTIC AIDSGENERAL ELECTRICAL DIAGNOSTIC PROCEDURESCONNECTOR REPAIRSBOSCH CONNECTORS (BSK)
2008 Chevrolet Uplander V6-3.9L

Bosch Connectors (BSK)

2008 Chevrolet Uplander V6-3.9LSECTION Bosch Connectors (BSK)


Bosch Connectors (BSK)

Tools Required

J-38125 Terminal Repair Kit

Terminal Removal Procedure

1. Disconnect the connector from the component.
2. Remove the wire dress cover, if necessary.
3. Push the wire side of the terminal that is being removed toward the connector and hold it in position.




4. Insert the J 38125-561 tool into the 2 cavities on each side of the terminal at the front of the connector and push until you feel the tool disengage the terminal retainers. See the release tool cross reference in the Reference Guide of the J-38125 to ensure that the correct release tool is used.
5. Carefully pull the terminal out of the connector. Always remember never use force when pulling a terminal out of a connector. If the terminal is difficult to remove, repeat the entire procedure.

Terminal Repair Procedure

Use the appropriate terminal and follow the instructions in the J-38125.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.