Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008UPLANDER LT, 3.9 1REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATSPOWER SEAT SYSTEMREPAIR INSTRUCTIONSMEMORY SEAT CONTROL MODULE REPLACEMENT

2008 Chevrolet Uplander LT, 3.9 1

Memory Seat Control Module Replacement

2008 Chevrolet Uplander LT, 3.9 1SECTION Memory Seat Control Module Replacement

Fig 1: Identifying Memory Seat Control Module

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the front bucket seat. Refer to Front Seat Replacement - Bucket . Remove the seat cushion cover and pad. Refer to Front Seat Cushion Cover and Pad Replacement .
1	Module, Memory Seat Refer to Control Module References for programming and setup information.
2	Screw, Memory Seat Module Bracket (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
3	Bracket, Memory Seat Module

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.