Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008UPLANDER LT, 3.9 1REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEEXTERIOR/INTERIOR TRIMEXTERIOR TRIMREPAIR INSTRUCTIONSROCKER PANEL MOLDING REPLACEMENTREMOVAL PROCEDURE
2008 Chevrolet Uplander LT, 3.9 1
Removal Procedure
2008 Chevrolet Uplander LT, 3.9 1SECTION Removal Procedure
- Remove the front lower rocker panel to wheelhouse molding screw.
- Open the doors in order to access the upper molding retainers.
- Use the J 38778 in order to remove the push-in retainers at the bottom edge of the rocker molding. See Special Tools .
- Using the J 38778 , remove the retainers at the top edge of the rocker panel molding. See Special Tools .
- Remove the rocker panel molding from the vehicle.
- Clean the body panel using a 50/50 mixture by volume of isopropyl alcohol and water.
- Dry the surface thoroughly before applying the new molding.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.