Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2008 Chevrolet Uplander LT, 3.9 1SECTION Removal Procedure
- Remove the rear wiper arm (5). Refer to Rear Window Wiper Arm Replacement .
- Remove the rear wiper motor drive shaft nut (6).
- Remove the washer (7) and seal (8) from the wiper motor drive shaft.
- Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
- Disconnect the electrical connector (1) from the rear wiper motor.
- Remove the rear wiper motor screws.
- Remove the rear wiper motor (3) from the liftgate (5).
- Remove the rear wiper motor from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.