Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008UPLANDER LT, 3.9 1REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTMIRRORSMIRROR SYSTEMSREPAIR INSTRUCTIONSPOWER MIRROR REPLACEMENT
2008 Chevrolet Uplander LT, 3.9 1
Power Mirror Replacement
2008 Chevrolet Uplander LT, 3.9 1SECTION Power Mirror Replacement
| Callout | Component Name |
|---|---|
|
NOTE:
Refer to Fastener Notice
. Fastener Tightening Specifications:
Refer to Fastener Tightening Specifications
.Preliminary Procedure: Remove the interior trim panel. Refer to Front Side Door Trim Panel Replacement
. |
|
| 1 | Nut, Mirror Outside Rearview (Qty: 3) Tighten: 10 N.m (89 lb in) |
| 2 | Mirror Assembly, Outside Rearview Tip: Disconnect the electrical connector if door has power mirror. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.