Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008UPLANDER LT, 3.9 1REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEMSREPAIR INSTRUCTIONSHIGH MOUNT STOP LAMP REPLACEMENT

2008 Chevrolet Uplander LT, 3.9 1

High Mount Stop Lamp Replacement

2008 Chevrolet Uplander LT, 3.9 1SECTION High Mount Stop Lamp Replacement

Fig 1: View Of High Mounted Stop Lamp

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
1	Screw, High Mounted Stop Lamp (Qty: 2) Tighten: 2 N.m (18 lb in)
2	Lamp Assembly, High Mounted Stop Tip: Pull the high mounted stop lamp assembly rearward to remove. Disconnect the electrical connector. There are no bulbs to be replaced, the lamp assembly has LED lights and must be replaced as an assembly.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.