SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008SILVERADO 2500 2WD V8-6.6L DSL TURBOREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESERVICE AND REPAIRREMOVAL AND REPLACEMENTALLISON - AUTOMATIC TRANSMISSIONTRANSMISSION HEAT SHIELD REPLACEMENT
2008 Chevrolet Silverado 2500 2WD V8-6.6L DSL Turbo

Transmission Heat Shield Replacement

2008 Chevrolet Silverado 2500 2WD V8-6.6L DSL TurboSECTION Transmission Heat Shield Replacement


Transmission Heat Shield Replacement

Removal Procedure





1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the front heat shield bolts (2).
3. Remove the front heat shield (1).
4. Remove the side heat shield bolt (4) and nut (5).
5. Remove the side heat shield (3).



Installation Procedure





1. Install the side heat shield (3).
Notice: Refer to Fastener Notice .


2. Install the side heat shield bolt (4) and nut (5).

* Tighten the bolt (4) to 17 N.m (13 lb ft).
* Tighten the nut (5) to 25 N.m (18 lb ft).


3. Install the front heat shield (1).
4. Install the front heat shield bolts (2).

Tighten the bolts (2) to 17 N.m (13 lb ft).

5. Lower the vehicle.


RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.