Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR SS, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT VIEWS & COMPONENT CONNECTOR END VIEWSCOMPONENT CONNECTOR END VIEWSBODY CONTROL MODULE (BCM) X3
2008 Chevrolet HHR SS, Standard
Body Control Module (BCM) X3
2008 Chevrolet HHR SS, StandardSECTION Body Control Module (BCM) X3
Body Control Module (BCM) X3
| Pin | Wire | Circuit | Function |
|---|---|---|---|
| A1 | 0.35 TN | 294 | Door Lock Actuator Unlock Control (-Panel Van) |
| 0.35 TN | 294 | Door Lock Actuator Unlock Control | |
| A2 | 0.35 TN | 294 | Door Lock Actuator Unlock Control (-Panel Van) |
| A3 | 0.35 D-BU/WH | 149 | Courtesy Lamp Supply Voltage |
| A4 | 0.35 GY | 295 | Door Lock Actuator Lock Control (-Panel Van) |
| 0.35 GY | 295 | Door Lock Actuator Lock Control (-Panel Van) | |
| A5 | 0.35 GY | 295 | Door Lock Actuator Lock Control |
| 0.35 GY | 295 | Door Lock Actuator Lock Control | |
| A6 | - | - | Not Used |
| A7 | 0.35 BN | 9 | Park Lamp Supply Voltage |
| A8 | 0.35 PK | 339 | Run/Crank Ignition 1 Voltage |
| A9 | 0.35 YE | 18 | Left Rear Stop/Turn Lamp Supply Voltage |
| A10 | 0.35 GY | 157 | Courtesy Lamp Control |
| A11 | - | - | Not Used |
| A12 | 0.35 D-GN | 19 | Right Rear Stop/Turn Lamp Supply Voltage |
| B1 | 0.35 TN | 694 | Driver Door Lock Actuator Unlock Control |
| B2 | - | - | Not Used |
| B3 | 0.35 RD/WH | 1240 | Battery Positive Voltage |
| 0.35 RD/WH | 1240 | Battery Positive Voltage | |
| B4 | - | - | Not Used |
| B5 | 0.35 BN | 4 | Accessory Voltage |
| 0.35 BN | 4 | Accessory Voltage (MN5) | |
| B6-B7 | - | - | Not Available |
| B8-B11 | - | - | Not Used |
| B12 | 0.35 GY | 8 | Instrument Panel Lamps Dimmer Switch Signal |
| 0.35 GY | 8 | Instrument Panel Lamps Dimmer Switch Signal | |
| C1-C2 | - | - | Not Available |
| C3 | 0.35 D-GN | 1301 | RAP Fuse Supply Voltage (Panel Van) |
| C4 | - | - | Not Used |
| C5 | 0.35 D-GN | 801 | Retained Accessory Power Fuse Supply Voltage |
| C6-C7 | - | - | Not Available |
| C8-C11 | - | - | Not Used |
| C12 | 0.35 OG | 228 | Windshield Washer Pump Control |
| D1 | 0.35 RD/BK | 142 | Battery Positive Voltage |
| D2 | - | - | Not Available |
| D3 | - | - | Not Used |
| D4 | 0.35 RD/WH | 840 | Battery Positive Voltage |
| D5 | - | - | Not Used |
| D6 | 0.35 PK | 739 | Ignition 1 Voltage |
| 0.35 PK | 739 | Ignition 1 Voltage (Panel Van) | |
| D7 | 0.35 PK | 1339 | Ignition 1 Voltage |
| 0.35 PK | 1339 | Ignition 1 Voltage | |
| D8-D9 | - | - | Not Used |
| D10 | 0.35 RD/BK | 442 | Battery Positive Voltage |
| D11 | 0.35 RD/WH | 640 | Battery Positive Voltage (UQ3) |
| D12 | 0.35 RD/BK | 242 | Battery Positive Voltage |
Connector Part Information
|
Terminal Part Information
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.