Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBâ—Ź LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR SS, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALBODY ELECTRICALWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT VIEWS & COMPONENT CONNECTOR END VIEWSCOMPONENT CONNECTOR END VIEWSENGINE CONTROL MODULE (ECM) X1 (L61/LE5)
2008 Chevrolet HHR SS, Standard
Engine Control Module (ECM) X1 (L61/LE5)
2008 Chevrolet HHR SS, StandardSECTION Engine Control Module (ECM) X1 (L61/LE5)
Engine Control Module (ECM) X1 (L61/LE5)
| Pin | Wire | Circuit | Function |
|---|---|---|---|
| 1 | 0.35 D-BU | 1161 | APP Sensor 1 Signal |
| 2 | - | - | Not Used |
| 3 | 0.35 BN | 4 | Accessory Voltage |
| 4 | - | - | Not Used |
| 5 | 0.35 D-GN | 335 | Low Speed Cooling Fan Relay Control |
| 6 | 0.35 L-GN/WH | 465 | Fuel Pump Relay Control (-Primary) |
| 7-10 | - | - | Not Used |
| 11 | 0.35 OG/D-GN | 7360 | Manual Transmission Clutch Position Sensor Return |
| 12 | - | - | Not Used |
| 13 | 0.35 BN | 5991 | Powertrain Relay Control |
| 14-17 | - | - | Not Used |
| 18 | 0.35 L-BU | 1162 | APP Sensor 2 Signal |
| 19 | 0.5 PK/BK | 1039 | Ignition 1 Voltage |
| 20 | 0.5 RD/WH | 840 | Battery Positive Voltage |
| 21 | 0.35 PU | 1272 | Low Reference |
| 22-23 | - | - | Not Used |
| 24 | 0.5 TN | 2759 | Low Reference |
| 25 | 0.35 OG/BK | 380 | A/C Refrigerant Pressure Sensor Signal |
| 26 | - | - | Not Used |
| 27 | 0.35 BN/WH | 419 | MIL Control |
| 28-29 | - | - | Not Used |
| 30 | 0.35 D-GN/WH | 459 | A/C Compressor Clutch Relay Control |
| 31 | - | - | Not Used |
| 32 | 0.35 PU/WH | 6386 | Starter Enable Relay Control |
| 33 | - | - | Not Used |
| 34 | 0.35 PU/WH | 6356 | VSS Signal Low |
| 35-36 | - | - | Not Used |
| 37 | 0.35 YE | 492 | Mass Air Flow Sensor Signal |
| 38 | - | - | Not Used |
| 39 | 0.35 PU | 1589 | Fuel Level Sensor Signal (+Primary) |
| 40 | - | - | Not Used |
| 41 | 0.35 BN | 1271 | Low Reference |
| 42 | 0.35 D-GN | 890 | Fuel Tank Pressure Sensor Signal |
| 43 | 0.35 TN/BK | 2500 | High Speed GMLAN Serial Data (+) |
| 44 | 0.35 TN | 2501 | High Speed GMLAN Serial Data (-) |
| 45 | 0.5 D-BU/WH | 7361 | Manual Transmission Clutch Position Sensor Supply |
| 46 | - | - | Not Used |
| 47 | 0.35 WH/BK | 1164 | 5-Volt Reference |
| 48-53 | - | - | Not Used |
| 54 | 0.35 BN/WH | 6354 | VSS Signal High |
| 55 | 0.35 L-BU | 20 | Stop Lamp Supply Voltage |
| 56 | - | - | Not Used |
| 57 | 0.35 D-GN | 6307 | Clutch Start Neutral Start Signal |
| 58 | 0.35 L-BU | 6289 | Intake Air Temperature Sensor Signal |
| 59-60 | - | - | Not Used |
| 61 | 0.35 L-GN | 6338 | Manual Transmission Clutch Position Sensor Signal Position |
| 62-65 | - | - | Not Used |
| 66 | 0.5 GY | 2709 | 5-Volt Reference |
| 67 | 0.35 TN | 1274 | 5-Volt Reference |
| 68-69 | - | - | Not Used |
| 70 | 0.5 WH | 1310 | EVAP Canister Vent Solenoid Control |
| 71-72 | - | - | Not Used |
| 73 | 0.8 PK/BK | 6341 | Powertrain Relay Contact Signal |
Connector Part InformationÂ
|
Terminal Part InformationÂ
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.