Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Testing
2008 Chevrolet HHR SS, StandardSECTION Component Testing
CAUTION:
Refer to SIR Caution
.
- Ignition OFF, disconnect the harness connector at the audio steering wheel control switch.
- Test for infinite resistance between the 10-volt reference terminal 2 and the signal terminal 4 (late production) or 1 (early production) with the switch in the open position.
- If less than infinite resistance, replace the switch.
- Test resistance values between the 10-volt reference terminal 2 and the signal terminal 4 (late production) or 1 (early production) with the switch closed in each position and verify readings are approximate to what the schematic reads.
- If values do not, replace the switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.