Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rear Side Door Window Regulator Replacement
2008 Chevrolet HHR SS, StandardSECTION Rear Side Door Window Regulator Replacement
| Callout | Component Name |
|---|---|
|
NOTE:
Refer to Fastener Notice
. Fastener Tightening Specifications:
Refer to Fastener Tightening Specifications .Preliminary Procedures
|
|
| 1 | Side Door Window Regulator Bolt (Qty: 2) Tighten: 10 N.m (89 lb in) |
| 2 | Side Door Window Regulator Bolt Tip: Loosen the bolt enough so that the regulator assembly will lift out of the t-slot in the door inner panel. Tighten: 10 N.m (89 lb in) |
| 3 | Rear Side Door Window Regulator Assembly Tip: Disconnect the electrical connector. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.