Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR SS, AUTOMATICREPAIR AND DIAGNOSISGENERAL INFORMATIONRESET PROCEDURESTIRE PRESSURE MONITOR SYSTEMSTPMS RESET PROCEDURESTIRE PRESSURE SENSOR LEARNNOTES
2008 Chevrolet HHR SS, Automatic
Tire Pressure Sensor Learn: Notes
2008 Chevrolet HHR SS, AutomaticSECTION Notes
NOTE:
Once the learn mode has been enabled, each of the sensor's unique identification (ID) codes can be learned into the RCDLR's memory. When a sensor's ID has been learned, the RCDLR sends a serial data message to the BCM to sound a horn chirp. This verifies the sensor has transmitted its ID and the RCDLR has received and learned it. The RCDLR must learn the sensor IDs in the proper order to determine correct sensor location. The first learned ID is assigned to left front, the second to right front, third to right rear and fourth to left rear.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.