Power Steering Control Module Scan Tool Information (except 2.0L)

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Power Steering Control Module Scan Tool Information (except 2.0L)
Power Steering Control Module Scan Tool Data Parameters

Parameter System State Expected Value Description
Operating Conditions:Β  Ignition ON
Battery Voltage - Varies This displays Volts. This is the current battery voltage.
Ignition Voltage - Varies This displays Volts. This is the current ignition voltage.
Motor Voltage + - Varies This displays Volts.
Motor Voltage - - Varies This displays Volts.
Steering Calibration - Varies This displays a numeric value.
Steering Shaft Torque - Varies This displays N-m.
Vehicle Speed - 0 km/h (0 mph) This displays km/h (mph). This is the current vehicle speed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.