Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 8 (ENGINE CONTROLS AND FUEL - 2.2L (L61) - DTC P0016 TO DTC P0420)DTC P0106COMPONENT TESTING
2008 Chevrolet HHR LT, 2.4 P, Automatic
Component Testing
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Component Testing
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
You must perform the Circuit/System Testing in order to verify the integrity of the MAP sensor circuits before proceeding with the Component Testing.
Skewed Sensor Test
- Ignition OFF, remove the vacuum source from the MAP sensor.
- Ignition ON, observe and record the scan tool MAP sensor pressure parameter. This is the first MAP sensor reading.
- With the J 23738-A or J 35555 apply 17 kPa (5 in Hg) of vacuum to the MAP sensor. Observe and record the scan tool MAP sensor pressure parameter. This is the second MAP sensor reading.
- Subtract the second MAP sensor reading from the first MAP sensor reading. Verify that the vacuum decrease is within 4 kPa (1 in Hg) of the applied vacuum.
- If the vacuum decrease is not within the specified range, replace the MAP sensor.
- With the J 23738-A or J 35555 , apply 34 kPa (10 in Hg) of vacuum to the MAP sensor. Observe and record the scan tool MAP sensor pressure parameter. This is the third MAP sensor reading.
- Substract the third MAP sensor reading from the first MAP sensor reading. Verify that the vacuum decrease is within 4 kPa (1 in Hg) of the applied vacuum.
- If the vacuum decrease is not within the specified range, replace the MAP sensor.
Erratic Signal Test
- Ignition OFF, remove the MAP sensor.
- Install a 3A fused jumper wire between the 5-volt reference circuit terminal 1 and the corresponding terminal of the MAP sensor.
- Install a jumper wire between the low reference circuit terminal 2 of the MAP sensor and ground.
- Install a jumper wire at terminal 3 of the MAP sensor.
- Connect a DMM between the jumper wire from terminal 3 of the MAP sensor and ground.
- Ignition ON, with the J 23738-A
or J 35555
, slowly apply vacuum to the sensor while observing the voltage on the DMM. The voltage should vary between 0-5.2 volts, without any spikes or dropouts.
- If the voltage reading is erratic, replace the MAP sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.